CleanGrip™
Heavy Duty
Cleaner
Bathtub and Floor Anti-Slip
Treatment
SELF INSTALLATION
INSTRUCTIONS
When used as directed, this specially
formulated cleaning program will assist
you
in keeping your bathtubs, floors, and other
surfaces anti-slip.
Follow the instructions provided and do not
change any of the process.
If you have any questions, please
call
1-877-882-4747
STEP 1: APPLYING
THE
CleanGrip™ Heavy Duty Cleaner on
Bathtubs
FOR IMMEDIATE ANTI-SLIP
RESULTS
AND WHEN
USING THE RECOMMENDED
SIX MONTH APPLICATION
PROGRAM
·
Close
the drain and put on rubber gloves. USE UNDILUTED. Spray the
cleaner onto the surface of the tub or floor and wait about 30
seconds
·
Use an
applicator pad and spread the treatment evenly around the entire
surface
·
Wait about
3 - 15 minutes. Again,
lightly brush area with applicator pad.
·
Open drain,
turn on water and flood rinse tub using applicator pad to assist in
swishing water around tub.
The tub is now ready for use. There will be no residue and
the surface does not need to dry.
STEP 2:
CLEANING AND
MAINTAINING THE SURFACE AFTER
TREATMENT
OR WHEN USING
CleanGrip™ Heavy Duty Cleaner
AS PART OF YOUR
DAILY BATHTUB CLEANING
PROGRAM
·
Mix a
solution of 4 oz of
CleanGrip™ Heavy Duty Cleaner and
Slip Resistant
Treatment with one gallon on water. (or put one oz.
of CleanGrip™ into a 32 oz. spray bottle). Spray onto the surface, let
it remain on the surface for about 2 minutes. Wipe with sponge, cloth or
pad. Rinse.
·
Use daily.
10-01
MATERIAL SAFETY
DATA
CleanGrip™
HEAVY DUTY CLEANER AND ANTI SLIP
TREATMENT
===========================================================================
PREPARED: 05-01-04
EMERGENCY PHONE:
877-882-4747
ADVANCED SAFETY
PRODUCTS
720 LANDIS
AVENUE
VINELAND, NJ 08360
--------------------------------------------------------------------------------------------------------------------------------
SECTION II: HAZARDOUS
INGREDIENTS
HAZARDOUS
INGREDIENTS
(CAS
#)
OSHA PEL
ACGIH TLV
OTHER LIMITS
<5.00%
AMMONIUM BIFLUORIDE
(1341-49-7)
3
PPM
N/A
N/A
SECTION 313
SUPPLIER NOTIFICATION
·
INDICATES HAZARDOUS INGREDIENTS WHICH ARE
TOXIC CHEMICALS SUBJECT TO THE REPORTING REQUIREMENTS
·
OF SECTION 313 OF THE EMERGENCY PLANNING AND
COMMUNITY RIGHT-TO-KNOW ACT OF 1986 AND OF 40 CFR
372.
THE CHEMICAL
NAME AND CAS# INFORMATION MUST BE INCLUDED IN ALL MSDS COPIED AND
DISTRIBUTED FOR THIS MATERIAL
SECTION
III: PHYSICAL/CHEMICAL
CHARACTERISTICS
BOILING
POINT: 212 DEGREES
F
SPEC. GRAVITY (WATER=1):
1.03
VAPOR PRESSURE
(mm.HG.): SAME AS
WATER
MELTING POINT:
N/A
VAPOR DENSITY
(AIR=1): SAME AS
WATER
SOLUBILITY IN WATER:
COMPLETE
EVAPORATION: (BuAc=1): SAME AS WATER
APPEARANCE AND
ODOR: YELLOW
LIQUID, LEMON ODOR
ph RANGE:
5.0-6.0
SECTION
IV: FIRE AND EXPLOSION
HAZARD DATA
FLASH POINT
(METHOD USED):
NONE
FLAMMABLE LIMITS:
N/A
LEL: N/A
VEL: N/A EXTINGUISHING
MEDIA:
NONE
SPECIAL FIRE
FIGHTING PROCEDURES:
FIREFIGHTERS SHOULD USE SELF-CONTAINED BREATHING
APPARATUS
SECTION
V: REACTIVITY
DATA
PRODUCT IS
STABLE.
CONDITIONS TO AVOID:
N/A
INCOMPATIBILITY
(MATERIALS TO AVOID):
AVOID CONTACT WITH OXIDIZERS.
HAZARDOUS
DECOMPOSITION OR BY-PRODUCTS:
NONE
HAZARDOUS
POLYMERIZATION WILL NOT OCCUR
CONDITIONS TO
AVOID: N/A
SECTION
VI: HEALTH HAZARD
DATA
ROUTE(S) OF
ENTRY:
INHALATION:
YES
SKIN: NO
INGESTION:
UNLIKELY
HEALTH HAZARDS
(ACUTE & CHRONIC)
CAN CAUSE SOME
SKIN IRRITATION IN SOME
INDIVIDUALS.
PROLONGED SPRAY MIST INHALATION
WILL HARM RESPIRATORY TRACT.
MEDICAL
CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: NONE
KNOWN
**********EMERGENCY AND FIRST AID
PROCEDURES**********
SKIN
CONTACT: IMMEDIATELY FLUSH WITH WATER
FOR AT LEAST 15 MINUTES, IF SKIN IS IRRITATED, SEE A
PHYSICIAN.
EYE
CONTACT:
IMMEDIATELY
FLUSH WITH WATER FOR AT LEAST 15 MINUTES, SEE
PHYSICIAN.
INGESTION:
DRINK PLENTY OF WATER THEN MILK OR MILK OF MAGNESIA, GET
MEDICAL ATTENTION.
INHALATION:
REMOVE TO FRESH AIR, ADMINISTER OXYGEN, GET MEDICAL
ATTENTION.
SECTION
VII: PRECAUTIONS FOR
SAFE HANDLING AND USE
WASTE DISPOSAL
METHOD: DISPOSE OF IN
ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.
STORAGE &
HANDLING: STORE IN A
COOL, DRY AREA. KEEP
CONTAINER CLOSED WHEN NOT IN USE. KEEP OUT OF REACH OF
CHILDREN.
SECTION
VIII: CONTROL
MEASURES
VENTILATION: LOCAL EXHAUST: AS REQUIRED TO MAINTAIN TLV
LIMITS.
SPECIAL: N/A
MECHANICAL:
N/A
OTHER: N/A PROTECTIVE
GLOVES:
RECOMMENDED
EYE
PROTECTION:
RECOMMENDED
CleanGrip™
HEAVY DUTY CLEANER AND ANTI SLIP
TREATMENT
SUPPLEMENTARY TECHNICAL
INFORMATION
CHEMICAL STAIN
RESISTANCE
Test
Results/Lab
MATERIAL
0-3 HOUR EXPOSURE
3-12 HOUR EXPOSURE
Glass
No effect
Slight Hazing
Stainless
Steel
No effect
Slight Hazing
Aluminum
No effect
Slight Discoloration
FPR Board
No effect
No effect
Wood
No effect
No effect
Carpet*
Could have discoloration
Could have discoloration
Grout/Tile
Cleaning Effect
Cleaning /Whitening
Concrete
Cleaning Effect
Cleaning Effect
Plumbing/Plastic, PVC
No effect
No effect
Plumbing/Copper
Brightening Effect
Brightening Effect
Plumbing/Chrome
Brightening Effect
Brightening Effect
Deck Brush/Nat.
or Syn.
No effect
No effect
Mop
Bucket/Plastic
No effect
No effect
Mop/Cotton/Syn.
No effect
No effect
Spray
Applicator
No effect
No effect
*All carpet is
different. Some carpets
may show no effect while others may show discoloration because of
the way they are manufactured and the dyes that are used. As with the use of all the
chemicals in your facility, floor and carpet cleaners included, care
should be taken around carpeting. Simply mask off the carpet
where it meets the tile surface or do not use CleanGrip™ within 1-3
feet of carpet. The
spray applicator will assist in the controlled use of the
product. Note: As with all chemical
products, clean up all unwanted spills as soon as
possible.
GENERAL
PROPERTIES
Color
Yellow
pH
6.0
Density
8.6#/gallon
Solubility in Water
Complete
Coverage (undiluted)
80 tubs/gallon (Undiluted)
Odor
Lemon
Inhalation/short term effect
None
Flammability
Non Flammable
Shelf Life
1 year minimum
